ОТ от близкото минало

[DRGeorgiev]

TANNOY Windsor 1980
Buckingham while maintaining the performance of the speaker system to a common value of the power handling capacity and efficiency.
Inputs are allowed to improve to an independent effect on low-woofer sound localization.
350Hz The following is a low cone-type woofer is equipped with a 3108.
Buckingham over the middle and high frequency 350Hz same coaxial-type two-way unit is equipped with a 2508.
This unit has been established to improve the directional diffuser. In addition, the magnetic circuit has been newly developed magnetic fluid-filled, I improve the quality and input resistance characteristics.
The built-in crossover network that is dedicated.
The end of the enclosure there are two types of rosewood and walnut.
Method 2-type 3-way bass reflex speaker system floor
For low-use units: 12inch cone-type (3108)
For middle and high range: 2-Way Coaxial
Frequency Response 40Hz ~ 20kHz ± 3dB
Allowable input 120W (continuous)
Output sound pressure level (New JIS) 92dB 1w/1m
Nominal impedance 8Ω
Crossover Frequency 350Hz, 3.5kHz
Dimensions Width 585 × height 825 × depth 405mm
Weight 57kg

[DRGeorgiev]

TANNOY Turnberry/HE 1998
While inheriting a design concept that corresponds to the desire afresh musical era, Tannoi prestige series speaker system.

Adopted a unit made by Kurutomyura woofer cone type with a hard edge to 10-inch Dual Concentric unit.
Computer analysis of the passage of sound inside the TW uses a horn tweeter horn, creating a wave of spherical waveguide formed by the exact precision, and improve high frequency characteristics of the midrange.

Screws and plates decorated with a gold-plated, high current switch is equipped with a lock to ensure high frequency level control circuit.
And poor contact caused by aging participants, such as signal distortion due to transmission loss and increased contact resistance, and to prevent adverse effects on sound quality.

The speaker terminals are also used for wiring the pins that can be driven by independent Konsentorikku dual woofer and tweeter.
The ground terminal has been equipped with a speaker unit and adjacent to the speaker terminals, you can easily connect to the ground as the power amplifier and speaker cable and wiring.

Enclosure, the volume and margin Motase and 100L, both sides of the front, the Department established two places open ports, Edinburgh / TWW same DPS (Distributed Port System) adopts a closed Tannoy own enclosure as it combines the growth of low-resolution and the type of bass reflex type, you have 10 new design for dual Konsentorikku inches.
The material is used on the front of the solid walnut natural materials are used in more extensive fleshy butt plate.

[DRGeorgiev]

TANNOY Super Red Monitor SRM15X 1980
Unit is similar to Super Red Monitor 15inch (38cm) Coaxial 2-way unit is equipped with a K3808.
The woofer cone of the moisture treatments, reducing the impact on quality due to changes in humidity. The voice coil is treated to withstand a continuous temperature rise. Edge is treated with more specialized to withstand prolonged abuse.
The Department has adopted the tweeter voice coil wire, lightweight aluminum and rigid aluminum alloy diaphragm.

2cm in thickness of the enclosure, the high-density boards are used Furontobaffuru good sound off, the inside is decorated with reinforcement throughout.
Exterior is a walnut finish, uses a brown color grille net.

Terminal is equipped with a multi-channel drive.
Method 1-type 2-way bass reflex speaker system floor
Units used for all frequencies: 15inch (38cm) Coaxial (K3808)
Frequency Response 52Hz ~ 20kHz ± 4dB
Nominal impedance 8Ω (5.5Ω min)
Allowable input
70Hz ~ 1kHz: 120W (continuous)
500W (peak)
1kHz ~ 20kHz: 60W (continuous)
250W (peak)
Output sound pressure level 94dB/W/m (50Hz ~ 20kHz)
114dB/120W/m (50Hz ~ 20kHz)
121dB/500W/m (peak)
Third harmonic distortion Less than 0.5% (90dB SPL, 60Hz ~ 20kHz)
2.0% (110dB SPL, 110Hz ~ 15kHz)
5.0% less (114dB SPL, 110Hz ~ 10kHz)
Crossover frequency 1kHz (12dB/oct)
Control network 1.5kHz ~ 4kHz (-1.5dB ~ +3.0 dB, 4 positions)
3kHz ~ 20kHz (-3.0dB ~ +3.0 dB, 5 positions)
5kHz ~ 20kHz (-1.5dB/oct ~ -6.0dB/oct, 4 positions)
In volume 175L
Dimensions Width 1020 × height 650 × depth 420mm
Weight 51kg

[DRGeorgiev]

TANNOY Super Red Monitor 1980
Monitor Red, Monitor Gold Dyuarukonsentorikkuyunitto type speaker system with floor to draw a pedigree.
The unit is 15inch (38cm) Coaxial 2-way unit is equipped with a K3808.
The woofer cone of the moisture treatments, reducing the impact on quality due to changes in humidity. The voice coil is treated to withstand a continuous temperature rise. Edge is treated with more specialized to withstand prolonged abuse.
The Department has adopted the tweeter voice coil wire, lightweight aluminum and rigid aluminum alloy diaphragm.
Volume 230L enclosure is a bass reflex duct design and multi-type. The plywood boards are using high compression, the Furontobaffuru Birch is a high hardness is used in the thickness of 2.5cm.
The exterior finish is a walnut finish, and brown color with a grill net.
Can be corrected by using the quality control of attached network.
The drive terminal is equipped with two multi-channel, multi-amp can be driven.
Method 1-type 2-way bass reflex speaker system floor
Units used for all frequencies: 15inch (38cm) Coaxial (K3808)
Frequency Response 50Hz ~ 20kHz ± 4dB
Nominal impedance 8Ω (5.5Ω min)
Allowable input
70Hz ~ 1kHz: 120W (continuous)
500W (peak)
1kHz ~ 20kHz: 60W (continuous)
250W (peak)
Output sound pressure level 94dB/W/m (50Hz ~ 20kHz)
114dB/120W/m (50Hz ~ 20kHz)
121dB/500W/m (peak)
Third harmonic distortion Less than 0.5% (90dB SPL, 50Hz ~ 20kHz)
2.0% (110dB SPL, 100Hz ~ 15kHz)
5.0% less (114dB SPL, 100Hz ~ 10kHz)
Crossover frequency 1kHz (12dB/oct)
Control network 1.5kHz ~ 4kHz (-1.5dB ~ +3.0 dB, 4 positions)
3kHz ~ 20kHz (-3.0dB ~ +3.0 dB, 5 positions)
5kHz ~ 20kHz (-1.5dB/oct ~ -6.0dB/oct, 4 positions)
In volume 230L
Dimensions Width 722 × height 1095 × depth 436mm
Weight 65kg

[DRGeorgiev]

TANNOY Super Red Monitor SRM12X 1980
Super Red Monitor Series floor type speaker system.
The unit is 12inch (30cm) coaxial type 2 uses a Ueisupikayunitto.
Of the paper cone woofer is designed to enhance the rigidity and humidity to prepare for the change versus input characteristics, and reduce the degree of fatigue in a paper cone to improve the durability of the edge further.
Are also trying to improve the voice coil and heat resistance characteristics.
And an internal crossover network, can be adjusted from the front.

Method 1-type 2-way bass reflex speaker system floor
Units used for all frequencies: 12inch (30cm) Coaxial (3149)
Frequency Response 50Hz ~ 20kHz ± 4dB
Nominal impedance 8Ω (5.5Ω min)
Allowable input
70Hz ~ 1kHz: 100W (continuous)
350W (peak)
1kHz ~ 20kHz: 50W (continuous)
100W (peak)
Output sound pressure level 92dB/1W/1m (50Hz ~ 20kHz)
111dB/100W/m (70Hz ~ 20kHz)
116dB/350W/m (peak)
Third harmonic distortion <1.0% (90dB SPL, 50Hz ~ 20kHz)
3.0% less (110dB SPL, 100Hz ~ 15kHz)
Crossover Frequency 1.4kHz (12dB/oct)
Network control 3kHz ~ 20kHz (-3.0dB ~ +3.0 dB, 5 positions)
5kHz ~ 20kHz (-3.0dB/oct ~ +1.5 dB / oct, 4 positions)
Volume in 68L
Dimensions Width 446 × height 850 × depth 279mm
Weight 30kg

[DRGeorgiev]

TANNOY Super Red Monitor SRM12B 1980
Method 1-type 2-way bass reflex bookshelf speaker system
Units used for all frequencies: 12inch (30cm) Coaxial (3149)
Frequency Response 55Hz ~ 20kHz ± 4dB
Nominal impedance 8Ω (5.5Ω min)
Allowable input
70Hz ~ 1kHz: 100W (continuous)
350W (peak)
1kHz ~ 20kHz: 50W (continuous)
100W (peak)
Output sound pressure level 92dB/W/m (55Hz ~ 20kHz)
111dB/100W/m (70Hz ~ 20kHz)
116dB/350W/m (peak)
Third harmonic distortion <1.0% (90dB SPL, 55Hz ~ 20kHz)
3.0% less (110dB SPL, 100Hz ~ 15kHz)
Crossover Frequency 1.4kHz (12dB/oct)
Network control 3kHz ~ 20kHz (-3.0dB ~ +3.0 dB, 5 positions)
5kHz ~ 20kHz (-3.0dB/oct ~ +1.5 dB / oct, 4 positions)
In volume 46.5L
Dimensions Width 400 × height 584 × depth 275mm
Weight 21kg

[DRGeorgiev]

TANNOY Super Red Monitor SRM10B1980
Super Red Monitor Series Compact bookshelf speaker system.
The unit is 10inch (25cm) coaxial type 2 uses a Ueisupikayunitto.
Method 1-type 2-way bass reflex bookshelf speaker system

Units used for all frequencies: 10inch (25cm) Coaxial (2558)
Frequency Response 50Hz ~ 20kHz ± 4dB
Nominal impedance 8Ω (5.5Ω min)
Allowable input
70Hz ~ 1kHz: 80W (continuous)
300W (peak)
1kHz ~ 20kHz: 50W (continuous)
100W (peak)
Output sound pressure level 90dB/1W/1m (55Hz ~ 20kHz)
110dB/100W/m (70Hz ~ 20kHz)
115dB/300W/m (peak)
Third harmonic distortion <1.0% (90dB SPL, 55Hz ~ 20kHz)
3.0% less (110dB SPL, 100Hz ~ 15kHz)
Crossover Frequency 1.2kHz (12dB/oct)
Network control 3kHz ~ 20kHz (-3.0dB ~ +3.0 dB, 5 positions)
5kHz ~ 20kHz (-3.0dB/oct ~ +1.5 dB / oct, 4 positions)
Volume in 35L
Dimensions Width 350 × height 524 × depth 270mm
Weight 18kgAnd an internal crossover network, can be adjusted from the front.

[DRGeorgiev]

Tannoy Litle Red Monitor

[DRGeorgiev]

Tannoy super Gold 12''

[DRGeorgiev]

TANNOY LITLE GOLD MONITOR